Factory Works 1020 12mm wheel adapters for RC10 1/4" axles RC10 RC10T RC10DS 10T DS 102-12M-WHL-DPT

 these vintage 12mm adapters fit the RC10 and RC10T with 1/4" axles. These precision machined aluminum adapters do NOT drive off the pin- the slot is only for pin clearance. These drive off the taper, and are a very tight fit. Please note that these are new old stock from the 1980s and were designed to fit axles of the day. Use a wheel nut to install them noting the position of the pin and slot. Modern rere axles are not the same precision and may require drilling to open the hole slightly. Once installed, you will find they run much more true than plastic adapters. These are designed for vintage offset wheels from Kyosho, when used with modern offset wheels the rear track will be very narrow and wheels are likely to rub